ProJET HORNET ECU controls turbines from behotec, Frankturbine, BF-Turbines, JetItalia, Hammer Engines ...
Example for HORNET 3
The VSpeak ECU Converter for HORNET ECU's emulates the IO BOARD and the TERMINAL.
The data that is displayed in the status displays of the TERMINAL can be transmitted by the ECU Converter over the telemetry channel to the radio.
With the VSpeak ECU Converter data from HORNET III and the earlier HORNET II can be transmitted.
Telemetry and ECU connector of the VSpeak ECU Converter are electrically isolated, to avoid repercussions of the turbine control to the receiver.
The VSpeak ECU converter is available for the following remote control systems:
Jeti Duplex (EX-Sensor / EX-Bus) A comprehensive test report is published in the JETPOWER 2016/1.
Multiplex MLink (MSB)
PowerBox Core P²-Bus
Spektrum X-Bus / SRXL2
The respective remote control system (except Spektrum X-Bus) can be set using the programming adapter and the HORNET TERMINAL. Individual parameters can also be set:
The VSpeak ECU Converter is updatable.
Detailed information about VSpeak ECU Converter HORNET can be found in the detailed manual.
With the VSpeak ECU Converter for Jeti Duplex and Graupner HoTT not only the data of the terminals can be displayed. With the help of the radio keys all inputs are possible. The handling is similar to the terminal of the ECU (see YouTube video).
Jeti Duplex EX
Futaba (single sensors)
more demo videos for Futaba S.BUS2: